(This may have been covered here before, but I could not find anything in my search efforts, so I thought I would share.)
On my Paulk Workbench I use 4" Bessy bar clamps to hold down my work. I separated the clamp from the bar by filing the nubs off the end of the bar so the clamp will come apart.
In use, I just reach under the table and insert the bar into whatever bench dog hole I need and reassemble the clamp. The whole process takes about 5 seconds and it is very handy.
On my Paulk Workbench I use 4" Bessy bar clamps to hold down my work. I separated the clamp from the bar by filing the nubs off the end of the bar so the clamp will come apart.
In use, I just reach under the table and insert the bar into whatever bench dog hole I need and reassemble the clamp. The whole process takes about 5 seconds and it is very handy.